Starts With Fusing Devil Crystal

The higher the grade of the Devil Crystal, the lower its success rate. Because the energy content of a Level 1 Devil Crystal was low, the success rate could reach 70%. However, there was no practical value at all. Moreover, this success rate could only be calculated after all the forging procedures were completed in a short period of time. There weren't many people in the world who could complete this forging procedure. The only thing that could be completed was the famous Forging Master. A famous master like Tadlin could only be counted as half. He could complete it when he was in good condition. However, most of them couldn't complete it. Otherwise, Tadlin wouldn't have only produced one Devil Sword.    

    

The probability of a second grade Devil Crystal being produced was about 50, and a third grade Devil Crystal was only 30%. A fourth grade Devil Crystal was reduced to 20%. Now, Reg wanted to forge a sixth grade Devil Crystal. The success rate of socketing a sixth grade Devil Crystal was only about 10%!    

    

According to normal algorithms, a 10% success rate would only be able to succeed once every 10 times. This kind of success rate would naturally make ordinary people not dare to try. Not to mention whether or not he could complete the forging process in a short period of time, even if he could complete it... Ordinary Forging Master would not be able to withstand this kind of success rate. After all, the cost of forging once was a huge sum of money. If he failed a few times, he would probably go bankrupt...    

    

The failure rate of the Devil Crystal embedding was mainly due to the difficulty of the integration of the Devil Crystal and sword. The integration speed was an unavoidable problem. Even the highest grade of Forging Master could not be avoided. They could only use all kinds of possible methods to increase the integration speed of the Devil Crystal and sword, increasing the probability of the integration.    

    

The Blood Grass that Reg had gathered this time was to increase the integration speed. The juice extracted from the Blood Grass could make the Devil Crystal and the sword fuse better, and increase the chances of integration.    

    

There was also a difference between the integration speed of the Devil Crystal and different materials. For top grade materials like the Cold Iron, there was a difference in the speed of integration. Usually, the degree of integration was very low. Even if one soaked the Cold Iron and the Devil Crystal in the Blood Grass juice, the degree of integration would still be very low. According to Tadlin, that would only increase the fusion rate a little. It could increase the fusion rate from 10% to 25%. And this was on the premise that... Reg's forging technique was perfect without any mistakes.    

    

Reg was quite confident about this. After experiencing that strange incident, Reg's brain seemed to have an incomparably strange and terrifying computing ability. As long as he could figure out the correct program, his actions would be like a programming homework. Without any external interference, he would be able to operate the operation in a standardized manner. Just like a machine.    

    

Reg even vaguely felt that he had other strange abilities, but he had not discovered them yet. However, this intuition was very clear.    

    

Seeing Reg put the Devil Sword soaked in Blood Grass juice back into the forging furnace and burn it, Reg and Tadlin became nervous.    

    

The Devil Sword soaked in Blood Grass juice had a strange blood-red color in the flame. Reg put the Devil Crystal soaked in Blood Grass juice next to him, and a small bottle of thick Blood Grass juice was also prepared.    

    

The Devil Sword finally turned red. Reg took a deep breath and inserted his left hand into the raging fire. He took out the red and high temperature Devil Sword.    

    

"Dang, dang, dang..."    

    

A series of knocking sounds rang out like a storm. Tadlin's eyes were wide open. He held his breath and did not move. He did not dare to make any movements. He was afraid that any of his actions would affect Reg. As a Forging Master, he naturally knew that at this moment. The slightest mistake would lead to a final failure.    

    

Reg's initial worry had been completely relieved. His mind was completely immersed in forging. Everything around him seemed to have been automatically blocked. His mind was only focused on the location of the Devil Crystal.    

    

After completing some confusing movements, Reg suddenly used his left hand to pick up the tier 6 Devil Crystal that had been soaked in Blood Grass juice. He suddenly inserted it into the hole that had been made earlier.    

    

Tadlin who was standing beside him felt his heart skip a beat. However, in an instant, Tadlin's eyes widened, filled with surprise and joy.    

    

It was seamless, and not the slightest bit inferior!    

    

Reg did not stop. He used his hand as a hammer, and continued to rest and reorganize. Tadlin looked at Reg's dazzling movements. His heart had been hanging high. He was afraid that the tier 6 Devil Crystal would explode into dust because of the failure of the installation.    

    

What Tadlin was worried about did not happen. The tier 6 Devil Crystal was finally knocked down by Reg's left hand like a violent storm. He stayed quietly on the sword, and when Reg finally stopped, he took a deep breath and poured the Blood Grass juice onto the sword. Tadlin felt as if his heart was about to stop beating.    

    

Success or failure depended on this moment.    

    

Under Reg and Tadlin's expectant gaze, the sixth grade Devil Crystal that was poured with the Blood Grass juice finally emitted a strong light. After that, it slowly dimmed and finally emitted a faint halo.